Maurice's EEW 6.0/6.1 Parts models on printables.

Bobbin Release Dial

This part requires an M6x1 machine screw. Here is one that would work: https://www.mcmaster.com/92005A422

Bottom

This part covers the bottom and can hold a TalentCell 12V/6000mAh battery pack. You can reuse the screws and rubber feet from the bottom that came with the EEW 6.0/6.1.

Flyer Arm Caps

This part clicks onto the end of the flyer arms.

Reducer

This part fits into the orifice hole on the front of your EEW 6.0/6.1. It helps reduce the yarn wobble when spinning thin yarn. After printing you may need to sand it's diameter slightly to make it fit better, or if the fit is too loose put a piece of tape around it to make the fit more snug.

Tension Dial

You can reuse the screw and spring that came with your original tension dial.

For more fiber tools from Dreaming Robots, see their store at www.dreamingrobots.com